How To Take Bearings Out Of Skateboard Wheels

How To Take Bearings Out Of Skateboard Wheels. Now, soak the bearings for almost 10 minutes in acetone or bearing solvent to remove the stain and rust from the bearings. If you don’t have it, no problem, use a ½” socket wrench because wheel nuts are usually 13mm, that’s ½”.

How To Replace Skateboard Wheel Bearings YouTube from www.youtube.com

Now remove the nuts of the. Now, soak the bearings for almost 10 minutes in acetone or bearing solvent to remove the stain and rust from the bearings. After executing the above steps, you can now clearly see the bearings.

Source: www.delongboard.com

Put a sharp tap on the case of. You will need to remove.

Source: www.youtube.com

To do this, you need a socket. Put a sharp tap on the case of.

1) Use Your Skate Tool Or 13Mm Wrench To Remove All 4 Axle Nuts.

Axle nuts are used to secure the skateboard wheels placed on the outer side. You can see the bearings on both the top and bottom side of the wheel. At the initial step, you need to remove the skate wheel from the truck.

This Should Be Done Gently And Slowly At A Downward Angle So That The Wheel Is Unaffected As The Bearing Is Removed.

Use a kitchen knife to scrape out bearings from an ice cube. Now, soak the bearings for almost 10 minutes in acetone or bearing solvent to remove the stain and rust from the bearings. After executing the above steps, you can now clearly see the bearings.

Don’t Worry About Destroying It Because You’re Replacing It.

So the foremost step is unscrewing the nuts. Don’t loose the washers that sit either side of the wheel,. You can do this by using a bearing puller or by prying them out with a flathead screwdriver.

You Will Need To Remove.

Once you remove the nuts and washer, you may remove the wheel. Candle wax is probably the easiest way to get bearings out without a bearing press or vice; Rate this post contents show 1 how to get bearings out of skate wheels 2 eliminating skateboard wheel bearings 3 cleaning up skateboard wheel bearings how to get bearings.

Now Pry Your Skateboard Wheels Out Before You Can Remove The Main Bearing Assembly.

If you have a skate tool, then utilize it. If you don’t have it, no problem, use a ½” socket wrench because wheel nuts are usually 13mm, that’s ½”. 1) remove the old bearings from the wheel.