How To Take Out Bearings On A Skateboard

How To Take Out Bearings On A Skateboard. You will need to remove. Set the nuts somewhere you will not lose them.

How To Remove Skateboard Bearings from www.thoughtco.com

1) use your skate tool or 13mm wrench to remove all 4 axle nuts. In this video i show how to remove bearings from hard stubborn wheels using basic tools most people have. Using either a skate tool or a 13mm wrench, remove all four of the axle nuts.

Source: www.youtube.com

Now, soak the bearings for almost 10 minutes in acetone or bearing solvent to remove the stain and rust from the bearings. If you know which wheel needs.

Source: www.thoughtco.com

Remove the axle nuts of your four skateboard wheels at the same time if you’re changing all the bearings. First, you will remove the axle nut that is on the center of the wheel.

Close The Lid And Shake.

Apply a force of the right hand on the wheel shaft. Be careful not to damage the axle in. You need to take the bearings out of the shields in order to perform.

Be Careful When You Remove The Axle Nuts That You Don't Lose Any.

Too much of anything isn’t good at all, and that’s why bearings get tired. Place one on top of each cutout and firmly press down into place. Now, soak the bearings for almost 10 minutes in acetone or bearing solvent to remove the stain and rust from the bearings.

1) Remove The Old Bearings From The Wheel.

Does your board sound like crinkling a chip bag as you roll around the park? Candle wax is probably the easiest way to get bearings out without a bearing press or vice; How to clean skateboard bearings with household items.

1) Use Your Skate Tool Or 13Mm Wrench To Remove All 4 Axle Nuts.

Using either a skate tool or a 13mm wrench, remove all four of the axle nuts. Be careful when removing your axle nuts not to lose any of the washers in the process. (this will be container 1) next place all the rubber seals and retainers in the other bottle with some warm soapy water and shake as.

When Installing New Bearings In Your Wheel.

Follow the below steps to have the bearings pout instantly. Put a sharp tap on the case of. The lifespan of skateboard bearings is between 1 to 2 years.